Sony plans to invest nearly $1 billion to strengthen image sensor production

Reuters June 22 news, Japan's Sony Corp. said on Friday that it will invest nearly 80 billion yen (about 997 million US dollars) to strengthen the production of image sensors, this is Sony's strategic move to enhance digital imaging business revenue, Mainly for smartphones, tablets, and other camera-equipped gadgets.

In the fiscal year ending March 31 this year, Sony recorded a net loss, but Sony said that it will still implement its plan to invest in a CMOS image sensor factory in Nagasaki, southern Japan, by September 2013, half of which will be The current business period is completed.

Sony said that after the completion of the new production line deployment, the output of the Nagasaki CMSO sensor plant will reach 60,000 wafers per month, and will be applied to Sony's own products while being sold to smartphone and tablet makers.

It is reported that, due to weak market demand, South Korea's Samsung and other overseas rivals such as fierce competition and other factors, Sony TV business has been in poor condition, in the past 9 years has accumulated more than 12 billion US dollars in losses. However, Sony is looking for ways to increase revenue and profits in other sectors. Sony expects Sony TV sales this year to 17.5 million units, a decline of 11%.

Kazuo Hirai, Sony's new president and chief executive, said in April this year that Sony's future depends on mobile devices, games and digital imaging services such as Xperia smartphones. His goal for these businesses is to set an overall sales volume of 8.5 trillion yen and an operating profit margin of more than 5% within two years.

Air Source Heat Pump

Air source heat pump
Cooling capacity: 20kW-50kW

Characteristics:
1.Structure. Panels and base frame are made from galvanized steel protected with polyester powder painting to ensure total resistance to atmospheric agents.
2.Compressor. Hermetic scroll type compressor, equipped with the crankcase heater and thermal protection with thermal overload cut-out and crankcase heater mounted on rubber vibration isolators.
3.Axial fan. External rotor type axial fans, equipped with single phase direct drive motors, low noise 6 poles, protection level IP54, provided with a protective outlet grille.
4.Evaporator. High efficiency and low pressure drop stainless steel (AISI 316) water exchangers, with anti-freeze heating element (option) and differential pressure switch, factory insulated with flexible close cell material.
5.Condenser. Coils are consisting of seamless copper tubes mechanically expanded into blue hydrophilic aluminum fins, 100% fully quality tested; sub cooling circuit to prevent freezing at the base (optional); protected with metal grill.
6.Desuperheater: High efficiency stainless steel brazed plate heat exchanger, factory insulated with flexible close cell material (optional).
7.Refrigerant circuit. Copper tube connection with charge valve, filter, sight glass, gas-liquid separator, thermostatic expansion valve, low pressure switch with automatic reset, high pressure switch with manual reset. The heat pump unit is completed also with 4-way valve, liquid receiver and one way valve.
8.Water circuit. Built with air vent valve, water drain connection, and female-threaded hydraulic connectors. Water pump (8kW-30kW), differential pressure switch. Expansion tank (8kW-30kW)
9.Electric panel. Consists of:
Compressor contactor
Compressor protection breaker
Fan motor protection breaker
Control circuit protection breaker
Phase sequence relay (only for 3-phase)
Programmable microprocessor controller
10.Optional
Additional electric heater embedded in the coils for defrosting in low temperature ambient. It must be factory installed
Stainless steel covering
Remote condenser
Tube in tube heat exchanger

Water circuit electric heater

Air Source Heat Pump Unit

Air Source Heat Pump,Hot Water Air Source Heat Pump,Heating Air Source Heat Pump,Scroll Air Source Heat Pump

Jinan Amrta Air Conditioning Co.,Ltd , https://www.waterchiller.pl

Posted on