Before using the charger to charge the electric forklift , it is necessary to first connect the charger's power cord to the mains power supply. It is necessary to intervene in an AC380V or AC220V power supply according to the labeling of the electric forklift's charger; then the charger and battery wires are The connection is good; open the battery dust cover of the electric forklift, this is a comparative advantage of the electric forklift has a very good cooling effect when charging; this time the charging switch can be opened to charge. After filling up the amount of points, turn off the on/off button of the charger and unplug the battery connector and the power plug of the electric forklift. Check carefully whether the electrolyte of the battery of the vehicle is in the normal range. If the electrolyte is not Sufficient, then need to increase the distilled water immediately to enable it to reach a normal use level.
Electric forklift use note:
1. When the electric forklift needs to be charged, the charging place should be a fixed site, and the charging place should have a good ventilation environment, low humidity, and can not have any suspicious flammable objects.
2. The ground of the charging field fixed by the electric forklift should be easier to drain and cut acid. Because when the vehicle is charging, it is very likely that electrolyte will drip onto the ground.
3. When the battery of an electric forklift is being charged, it will generate hydrogen, so don't smoke around it when it is charging or let any fire source come close to it. If an explosion occurs, it will be a tragedy.
4. During the entire process of charging the vehicle, be careful not to force the plug of the battery to be pulled out. If there is an electrical spark, it will be very dangerous.
5. If the electrolyte is dripped after the battery is charged, the electrolyte needs to be flushed with clean water, and the electrolyte remaining on the battery of the electric forklift is also required to be washed out.
6. The electrolyte in the battery of an electric forklift is corrosive and toxic. Therefore, no matter what the operating conditions, care must be taken to avoid contact with the electrolyte in any part of the body.
EVA Traction Pad is the tail pad to be sticked on the surfboard. It comes with center arch and kick tail, which allow surfers to control the direction and stability when surfing in the sea.
The design of surfboard traction pad can be in one piece, two pieces, or three pieces basically. The standard the classical texture for traction pad would be diamond like texture, as it can provide the stronger grip among all of them.
The EVA color connect logo is made along with the pad itself. Unlike the PVC logo, it is also EVA material same as pad, and also shows with the texture. The design of this logo can not be too detailed and small, it needs to be larger and simpler so that we can use the different color EVA material to connect them.
Eva Traction Pad,Non-Skip Traction Pad,Traction Pad,Surfboard Tail Pads,Grip Tail Pad,Eva Tail Pad
Huizhou City Melors Plastic Products Co., Limited , https://www.thefoammaster.com