A distiller is an electric heating device used to prepare distilled water. In the process of using the distiller, the cold water for burning the distilled water is required to meet the needs and cannot be interrupted. Otherwise, the heater will be damaged due to dry burning. Therefore, installing a set of water cut off automatic protection device to the distiller can ensure the safe operation of the distiller under sudden water cut.
After the whole device is installed, open the valve of the water supply pipe, and the water enters the cylinder body from the upper inlet of the right cylinder body. After decompression of the right cylinder, water enters the left cylinder from the lower communicating tube. Part of the water enters the distiller through the lower nozzle. The other part of the water lifts the float in the cylinder under the action of buoyancy. At the same time, the iron flag on the pull cord left the proximity switch and moved to the left end of the bracket. When the iron flag leaves the proximity switch, the contact point of the proximity switch actuates the contact point of the main circuit and sends power to the distiller to begin work. When the water supply line interrupts the water, the water in the left cylinder gradually decreases, causing the float to fall to the bottom of the cylinder. At the same time, the iron flag is pulled back to the right end, giving a signal to the proximity switch to make the contact point of the main loop of the control circuit act, cut off the power supply of the distiller, and the distiller stops working, which plays a role of water cut control and protection.
After adding the water cutoff device to the distiller, the continuous production of water is realized, the working efficiency of the distiller is improved, and electric energy is saved; attention is paid to periodically cleaning the inner surface of the retort tube and the surface of the electric heating tube at an appropriate time according to the quality of the water. Scale, so as not to affect the heat transfer efficiency, burn out the heating element; the gap between the proximity switch and the iron flag should be adjusted properly, too large or too small will affect the sensitivity of its movement. After testing, when selecting TWK220) A10JK type proximity switch, the clearance should be less than 8mm.
Add Wechat to browse professional information anytime, anywhere: 
Ridge Cap Roll Forming Machine
Ridge Cap Roll Forming Machine
Colored steel ridge cap forming machine is the machine to produce ridge caps for top part of roof, it is covered on the joint part of the two roofing sheet.
The Ridge cap tile will be used on the ridge of the roof or other place.
It can be used well with the glazed tile produced by roll forming machine.
It can be used well with the trapezoidal tile produced by roll forming machine.
Technique parameters
(1) Processing material: Aluminum/galvanized steel/colored steel coil
(2) Material thickness:0.3- 0.8mm
(3) Product size:5800*1500*1300mm
(4) Main motor power: 4kw
(5) Pump power:4kw
(6) Shaft diameter: 75mm
(7) Forming steps: 13 steps
(8) Roller material: high grade 45# steel, hard Chromium plating
(9) Main frame: 300H Steel
(10) Medium plate thickness: 16mm
(11) Speed:8-12m/min
(12)Material of the cutting blade: Cr 12 mould steel with quenched treatment
(13) Control system: PLC computer control
(14) Power supply: 380V, 3 Phase, 50Hz (can change as customers request)
Components of line
1.Decoiler 1 unit
2.Roll Forming System 1 unit
3.Cutting Device 1 unit
4.Hydraulic Station 1 unit
5.PLC control system 1 unit
Working Flow:
Loading coil – decoiling – guide feeding – main roll forming – hydrarlic cutting – finished products
Ridge Cap Roll Forming Machine
Ridge Cap Roll Forming Machine,Metal Ridge Cap,Roll Forming Machine,Metal Ridge Cap Roll Forming Machine
CANGZHOU DIXIN ROLL FORMING MACHINE CO., LTD , https://www.hebeimachine.com