What are the installation methods of the wing gate?

Wing gate , one of the channel management equipment, is mainly used for pedestrian channel management; it has the characteristics of quick opening, safety and convenience, and is an ideal management and grooming device for pedestrians with high frequency access and passage; it is widely used in airports, subway stations and stations. , docks, attractions, parks, student dormitories, pedestrian walkways, etc.

First, the wing gate determination program. In the communication with the customer to determine the program, the width of the site, the length of how much, clearly can install several machines, is the choice of vertical wing gate, or bridge wing gate, vertical wing gate Dimensions: 420x330x980 (mm), bridge wing Brake dimensions: 1200x280x1000 (mm), wing gate to chassis size 510mm, ie vertical wing gate footprint: 420x (330+510), bridge wing gate covers 1200x (280+510), in the determination When selecting the type, fully consider the gap between the gate and the gate, the floor space of each wing gate, the placement position, how to route (it is to take the open line or the dark line), the plan is fixed, the target is fixed, waiting for the wing gate to on site.

Second, fixed position wiring. According to the previously determined scheme, the specific dimensions of the installation of the wing gate are clearly defined, and the pre-buried pipe is prepared. The gap between the gate and the gate is 50-100mm, and the upper cover can be opened to prevent adjustment of the machine, maintenance, etc. Leave a gap, between the gate and the gate, pre-bury two plastic tubes of 6 minutes to 8 minutes, one hose to go the power line (strong power), the other hose to go the signal line (weak power), can not connect the power cord and The signal line also walks a hose at the same time, which will affect the effect of communication. The pre-embedded tube should be exposed to the ground 30-40mm high. The vertical wing gate should be in the middle of the machine. The bridge wing should be on both sides. (Because the bottom of the bridge wing is closed).

Third, fixed adjustments. The fixed bottom is fixed with 4-M10x100 expansion screws, which can't be swayed. The whole machine is horizontal and the appearance is the same. (The straight line is straight before the fixing, the vertical and horizontal lines are consistent). The wing gate and the wing gate are connected in series, one by one. Straight lines can be used normally.