Analysis of common failures of nutritional powder production line

The common faults in the nutrient powder production line mainly include loss of control of the electric valve, uneven distribution of the material, and rotation of the electric valve motor while the valve is not rotating. The specific conditions and treatment methods of the nutrient powder production line above are:

Electric valve out of control. When this happens, check for any foreign matter stuck in the valve body. If it is found, remove it immediately. The material level detection device is not in the proper position. It needs to be repositioned properly. The sensor switch on the electric valve is damaged or improperly positioned. Replace the new sensor switch or adjust the mounting position. The material is not uniform. The exclusion method for this situation is to correct the levelness of the two ends of the forming roller, whether there is a gap between the squeegee and the forming roller, and if necessary, the upper fastening bolt needs to be adjusted. The electric valve motor rotates and the valve does not rotate: In this case, replace the new coupling or tighten the coupling fixing bolts.

The nutrient powder production line should be operated in strict accordance with the correct operation method during the use process, and the production workers who use the nutrient powder production line should be trained to use scientific operations to minimize the failure of the nutritional powder production line during use.