From the technical point of view, the hydraulic hybrid bus is a technology that recovers the braking energy of the bus frequently braked by the hydraulic power system, and then uses the recovered energy to drive the bus to start and accelerate. Getting started is the most fuel-intensive phase of the bus. If the energy recovered by the brakes is used in the starting and acceleration stages, it will save energy. Take the diesel bus with a length of 11 meters and a total weight of 15 tons as an example. The average recovery of 20 ml of diesel oil per brake is 1000 times per day, which can save 7,000 liters of diesel per year. The most important stages of bus emissions are the parking idle speed and the low start phase. The hydraulic hybrid bus's start-up and low-speed engines can not be driven. The engine can be automatically turned off when the vehicle is idling, thus eliminating or greatly reducing the black smoke and other emissions during start-up, acceleration and parking idling. %.
The first difference with other types of new energy vehicles is that hydraulic hybrid buses can be installed not only on new cars, but also on existing vehicles. After installation, the structure and performance of the original buses are not changed. The second difference with other types of new energy vehicles is that there is an independent engine drive mode, which is driven by the performance and power of the original bus; there is also an alternate driving mode of engine power and hydraulic power, with the performance of the hydraulic hybrid bus. Power driving. Therefore, hydraulic hybrid buses are not only equipped with new buses with an annual growth of 50,000, but also active buses with a capacity of 350,000. The energy-saving and emission-reducing performance of most active buses in China is not up to standard, and more than 200 billion yuan has been completely completed. Since the cost of installing the hydraulic hybrid system is not more than 70,000 yuan, the emission reduction and energy-saving performance of the original bus can reach the Euro III or Euro IV standard, which is favored by the active bus. The third difference with other types of new energy vehicles is that many new energy vehicles require supporting ground facilities, including funding, site and safety issues, such as alcohol, ether fuel vehicles, gas stations, biodiesel. Fuel-fueled vehicles require gas stations, hydrogen-fueled vehicles need hydrogen refueling stations, electric vehicles need charging stations, etc., while hydraulic hybrid buses do not need to increase ground facilities, and there are no related problems.
API 5L Line Pipe SSAW Steel Pipe
Certificate: EN10217, EN10219, API 5L PSL1/ PSL2, API 5CT
Out Diameter: 168.3mm –3048mm
Wall Thickness: 3.2mm-30mm
Length: Up to 50m
Steel Grade:
API 5L: GR A, GR B, X42,X46, X56, X60,X65,X70
ASTM A252 GR 1, GR 2, GR 3
ASTM A53: GR A, GR B, GR C, GR D
BS 4360: Grade 43, Grade 50
EN: S275, S275JR, S355JRH, S355J2H
Surface: Fusion bond Epoxy coating, Coal Tar Epoxy, 3PE, Vanish Coating, Bitumen Coating, Black Oil coating as per customer`s requirement
Test: Chemical Component Analysis, Mechanical Properties (Ultimate tensile strength, Yield strength, Elongation), Technical Properties (Flattening Test, Bending Test, Blow Test, Impact Test), Exterior Size Inspection, Hydrostatic Test, X-ray Test.
SSAW Steel Pipe
Piling SSAW Steel Pipe, API 5L SSAW Steel Pipe, Big Diameter SSAW Steel Pipe, Structural SSAW Pipe
Cangzhou Weiheng Pipe Industry Co.,Ltd , http://www.czweiheng.com