The layout of the inclined well of the bucket and the technical requirements for the inclined shaft can refer to the relevant regulations of the inclined shaft of the truck. At the same time, the following special requirements for the lifting of the inclined shaft of the bucket should also be considered:
    ( 1 ) Mines with large ore aggregates and large production scales, in order to extend the service life of the buckets and increase the bucket lifting capacity, underground crushing stations should generally be installed;
    ( 2 ) The bucket well shall not double as an entry into the wind well;
    (3 ) Line layout: Double-dip bucket inclined shafts are generally laid in two lanes. Only one level of mining can be arranged with one or three rails, and a double-track stagger in the wellbore;
    ( 4 ) Improve the yard line type: Under the condition of many loading points and short transportation lines, the loading and unloading station is double line; or only a single line yard, only one funnel gate is installed at the loading point, which can reduce the diverticulum at the loading point. Quantity of work;
    ( 5 ) The inclined shaft of the bucket should be equipped with corresponding diverticulum, such as loading equipment chamber, mine warehouse, signal chamber, shelter room, sprinkling mine clearing roadway and water pumping room .
Nox Sensor 12V for Ben zcar, auto parts 12V nitrogen and oxygen sensor, suitable for exhaust treatment of Mercedes Benz. Nitrogen and oxygen sensor is one of the key components of SCR post-treatment system. It is used to measure the concentration of nitrogen and oxygen in engine exhaust to meet the needs of closed-loop control of engine aftertreatment system and on-board OBD diagnostic system. It can be applied to gas engine or diesel engine. Its structure includes ceramic probe, cable and processing chip controller, which is connected with ECU through can communication. The effects of nitrogen and oxygen sensor damage are as follows: 1. If the nitrogen and oxygen sensor is damaged, the diesel control system is in an open-loop state, that is, the emission data cannot be accurately fed back, and the engine control unit cannot accurately adjust the emission. At this time, the vehicle's emission must exceed the standard. If it always exceeds the standard, the service life of tail gas emission treatment equipment will be shortened. 2. Because it is a key component for measuring the excessive exhaust of diesel vehicles. If it is damaged or works poorly, it will directly cause multiple fault lights of the engine to turn on. At the same time, there will be relevant fault storage records in the control unit. 3. The damage of nitrogen and oxygen sensor will lead to the disorder of diesel combustion control, resulting in weak acceleration, idle jitter and failure to start. Once there is a problem, the nitrogen and oxygen sensor needs to be replaced in time. It is usually installed at the rear end of the catalyst in the exhaust pipe.
Nox Sensor 12V For BENZ car,Auto parts 12V nitrogen and oxygen sensor, Mercedes Benz 12V nitrogen and oxygen sensor, Mercedes Benz engine parts 12V nitrogen and oxygen sensor
Ruian OKOOO Electronic Technology Co., LTD , https://www.okoosensor.com